Virginia Regulatory Town Hall

Proposed Text

highlight

Action:
Update the Industrialized Building Safety Regulations
Stage: Proposed
 
13VAC5-91-10

13VAC5-91-10. Definitions.

The following words and terms when used in this chapter shall have the following meanings unless the context clearly indicates otherwise.

"Administrator" means the Director of DHCD or his designee.

"Approved" as applied to a material, device, method of construction, registered building, or as otherwise used in this chapter means approved by the administrator.

"Building official" means the officer or other designated authority charged with the administration and enforcement of the USBC, or duly authorized representative.

"Closed panel construction" means a method of construction utilizing individual wall, roof, or floor components (panels) manufactured off site for installation or assembly at the construction site, where a portion of the component cannot be inspected at the building site without disassembly or damage to the component.

"Compliance assurance agency" means an architect or professional engineer registered in Virginia, or an organization, determined by DHCD to be specially qualified by reason of facilities, personnel, experience, and demonstrated reliability, to investigate, test and evaluate industrialized buildings; to list such buildings complying with standards at least equal to this chapter; to provide adequate follow-up services at the point of manufacture to ensure that production units are in full compliance; and to provide a label as evidence of compliance.

"DHCD" means the Virginia Department of Housing and Community Development.

"ICC" means the International Code Council, Inc.

"Industrialized building" means a combination of one or more closed panels, sections or modules, subject to state regulations and including the necessary electrical, plumbing, heating, ventilating, and other service systems, manufactured off-site and transported to the point of use for installation or erection, with or without other specified components, to comprise a finished building. Manufactured homes defined in § 36-85.3 of the Code of Virginia and certified under the provisions of the National Manufactured Housing Construction and Safety Standards Act (42 USC § 5401 et seq.) shall not be considered industrialized buildings for the purpose of this law.

"Label," "certification label," or "compliance assurance agency certification label" means the label required by 13VAC5-91-210.

"Model" means a specific design of an industrialized building designated by the producer of the building including production buildings with variations and options that do not affect compliance with the standards governing structural, plumbing, mechanical, or electrical systems or any other items governed by this chapter.

"Registered" means an industrialized building which displays a registration seal issued by DHCD in accordance with this chapter.

"Seal," "registration seal," or "Virginia registration seal" means the seal required by 13VAC5-91-260.

"SBCO" means the State Building Codes Office within DHCD.

"State Review Board" means the Virginia State Building Code Technical Review Board as established by § 36-108 of the Code of Virginia.

"This law" means the Virginia Industrialized Building Safety Law as embraced in Chapter 4 (§ 36-70 et seq.) of Title 36 of the Code of Virginia.

"USBC" means the Virginia Uniform Statewide Building Code (13VAC5-63).

13VAC5-91-20

13VAC5-91-20. Application and compliance.

A. In accordance with § 36-81 of the Code of Virginia, registered industrialized buildings shall be acceptable in all localities as meeting the requirements of the Industrialized Building Safety Law (Chapter 4 (§ 36-70 et seq.) of Title 36 of the Code of Virginia), which shall supersede the building codes and regulations of the counties, municipalities and state agencies. Local requirements affecting industrialized buildings, including zoning, utility connections, preparation of the site and maintenance of the unit shall remain in full force and effect. All building officials are authorized to and shall enforce the provisions of the Industrialized Building Safety Law (Chapter 4 (§ 36-70 et seq.) of Title 36 of the Code of Virginia) and this chapter.

B. In accordance with § 36-78 of the Code of Virginia, no person, firm or corporation shall offer for sale or rental, or sell or rent, any industrialized building subject to any provisions of this chapter unless it conforms with the applicable provisions of this chapter.

Further, any industrialized building constructed before January 1, 1972, shall remain subject to the ordinances, laws or regulations in effect at the time such industrialized building was constructed. Additionally, as a requirement of this chapter, any industrialized building bearing the label of a compliance assurance agency shall remain subject to the provisions of this chapter that were effective when such building was constructed, regardless of whether the building has been relocated.

C. In accordance with § 36-99 of the Code of Virginia and in accordance with the USBC, the installation or erection of industrialized buildings and alterations, additions, or repairs to industrialized buildings are regulated by the USBC and not this chapter. The USBC provides for administrative requirements for permits, inspections, and certificates of occupancy for such work.

D. The use of off-site manufactured intermodal freight containers, moving containers, or storage containers as building modules or components of an industrialized building must be approved by the administrator in accordance with 13VAC5-91-150.

In reviewing the use of intermodal freight containers as structural building components, the administrator will accept evaluation reports from accredited third-party evaluation services.

E. Off-site manufactured intermodal freight containers, moving containers, and storage containers placed on site temporarily or permanently for use as a storage container are not subject to this chapter.

13VAC5-91-150

13VAC5-91-150. When modification may be granted.

The administrator shall have the power upon request in specific cases to authorize modification of this chapter so as to permit certain specified alternatives where the objectives of this law can still be fulfilled. Such request shall be in writing and shall be accompanied by the plans, specifications, and other information necessary for an adequate evaluation of the modification requested. In reviewing the use of alternative methods or materials, the administrator may consider evaluation reports from accredited third-party evaluation services.

13VAC5-91-160

13VAC5-91-160. Use of model codes and standards.

A. Industrialized buildings entering the production assembly line after the effective date of the 2015 2018 edition of this chapter shall comply with all applicable requirements of the codes and standards listed in subsection B of this section except that the following codes and standards may be used for industrialized buildings entering the assembly line during a one-year period after the effective date of the 2015 2018 edition of this chapter:

1. ICC International Building Code - 2012 2015 Edition

2. ICC International Plumbing Code - 2012 2015 Edition

3. ICC International Mechanical Code - 2012 2015 Edition

4. National Fire Protection Association Standard Number 70 (National Electrical Code) - 2011 2014 Edition

5. ICC International Fuel Gas Code - 2012 2015 Edition

6. ICC International Energy Conservation Code - 2012 2015 Edition

7. ICC International Residential Code - 2012 2015 Edition

B. The following documents are adopted and incorporated by reference to be an enforceable part of this chapter:

1. ICC International Building Code - 2015 2018 Edition

2. ICC International Plumbing Code - 2015 2018 Edition

3. ICC International Mechanical Code - 2015 2018 Edition

4. National Electrical Code - 2014 2017 Edition

5. ICC International Fuel Gas Code - 2015 2018 Edition

6. ICC International Energy Conservation Code - 2015 2018 Edition

7. ICC International Residential Code - 2015 2018 Edition

Note: As the 2015 2018 editions of the International Codes are incorporated by reference as the construction standards for use with these regulations, this chapter is also referred to as the 2015 2018 edition of the Virginia Industrialized Building Safety Regulations or the 2015 2018 edition of this chapter.

The codes and standards referenced above may be procured from:

 

International Code Council, Inc.
500 New Jersey Avenue, NW, 6th Floor
Washington, DC 20001-2070

13VAC5-91-260

13VAC5-91-260. Registration seal for industrialized buildings.

A. Registered industrialized buildings shall be marked with approved registration seals issued by the SBCO. The seals shall be applied to a registered industrialized building intended for sale or use in Virginia prior to the shipment of the building from the place of manufacture. The seals shall be applied by the compliance assurance agency or by the manufacturer when authorized to do so by the compliance assurance agency.

B. Registered industrialized buildings shall bear one registration seal on each manufactured section or module, or, as an alternative, the registration seal for each manufactured section or module may be placed in one location in the completed building.

C. Closed panel construction shall require one registration seal for every 600 square feet, or part thereof, of floor area.

D. Approved registration seals shall be purchased by the compliance assurance agency from the SBCO in advance of use. The fee for each registration seal shall be $75. Fees shall be submitted by checks made payable to "Treasurer of Virginia" or shall be submitted by electronic means. Payment for the seals must be received by the SBCO before the seals can be sent to the user. The compliance assurance agency shall maintain permanent records of seals purchased, including a record of any manufacturers receiving such seals.

D. E. To the extent practicable, the registration seal shall be installed so that it cannot be removed without destroying it. The seal shall be applied in the vicinity of the electrical distribution panel or in another location that is readily accessible for inspection and shall be installed near the certification label.

E. F. In accordance with § 36-85.1 of the Code of Virginia, any person or corporation having paid the fee for an approved registration seal that it will not use may, unless and except as otherwise specifically provided, within one year from the date of the payment of any such fee, apply to the administrator for a refund, in whole or in part, of the fee paid; provided that no payment shall be recovered unless the approved registration seal is returned unused and in good condition to the administrator. Additionally, as a requirement of this chapter, an administrative and processing fee of 25% of the amount of the refund due shall be deducted from the refund; however, such deduction shall not exceed $250.

13VAC5-91-9999

DOCUMENTS INCORPORATED BY REFERENCE (13VAC5-91)

International Code Council, 500 New Jersey Avenue, NW, 6th Floor, Washington, DC 20001-2070 (http://shop.iccsafe.org/codes.html):

ICC International Plumbing Code - 2012 2015 and 2015 2018 Editions

ICC International Mechanical Code - 2012 2015 and 2015 2018 Editions

ICC International Building Code - 2012 2015 and 2015 2018 Editions

ICC International Residential Code - 2012 2015 and 2015 2018 Editions

ICC International Fuel Gas Code - 2012 2015 and 2015 2018 Editions

ICC International Energy Conservation Code - 2012 2015 and 2015 2018 Editions

NFPA 70, National Electrical Code - 2011 2014 and 2014 2017 Editions, National Fire Protection Association, 1 Batterymarch Park, Quincy, MA 02169‑7471 (http://www.nfpa.org/)

ASTM Standard Number E541‑10 - Standard Specification for Agencies Engaged in System Analysis and Compliance Assurance for Manufactured Building, American Society for Testing and Materials, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959 (http://www.astm.org/)